Horizontal bar Center - start of driving in of nails, lead the process toward the edges.Or on top of a vertically mounted rails, going to the floor.After finishing mounting, you need to move the bar up and down if the course turns free, installation is correct.
VINYL SIDING INSTALLATION INSTRUCTIONS VIDEO FREE
Uneven, bent nails, fasteners, screwed on the edge of the perforation prevents proper expansion strips, panels, warp the surface.It is required that the panel had free course, in other words, the nails should not touch obreshetochnogo layer before reaching him at least a millimeter.In case if you make it hard nails, use self-tapping screws.They screw up completely, spun at turn back.Select the mounting step - 40-45 cmĬan not pierce it with nails and screws vinyl.The size of perforation holes, if you want to drive a fastening element side, you can increase the punch.If your edge is constantly windy, the hat Gvozdkov or screw lay rubber or PVC washer.Joining elements must also take into account the temperature gaps.ĭuring installation, you must also make allowances for a cool environment.Heat means that the siding has lengthened, and at low rates, gaps need to be increased, as a warming strap stretches.It is best to finish all the work with PVC to sub-zero temperatures. To siding is not warped, be sure to take into account tolerances - read about the installation of crates under the siding.Īttachment size is chosen such that they are immersed in the batten at least 30 millimeters in diameter on the heads of nails or screws are selected by 8 mm.Mounting set straight, will lead to the fact that the straps and stand up straight, deformed.Expansion evenly, but the extension is in direct proportion to the length of the original panels.You can not drive nails and screws to fasten close to the vinyl flooring. Use corrosion nails (galvanized, aluminum, steel) or screws, setting panel.Siding will last 50 years, if all fasteners zaschischenyot destruction.
Can not attach siding directly to the wall: it impairs the movement of air, it leads to the formation of mold and mildew.For crates to choose well-dried wood.wood humidity is 12-15%.Or perform a lattice for attaching metal siding (suitable as if the walls of aerated concrete, brick or witty of aerated concrete, as well as in those cases when you need to perform the trim, using a heater).Wood treated ognebiozaschitoy.It is recommended to refer furring strips two feet from each other, and when the windy climates step is reduced to a few dozen centimeters.The depth of the lattice strips is determined by the presence of a heater.After attaching the panel so that the buckle locks no longer treat the panel.Once connected, the lock, the tension latch with external influences will be too strong and can damage the panel.
0 kommentar(er)
